Before building the distribution, read through the OS-specific README
file in xc/programs/Xserver/hw/xfree86/doc that is relevant to
you. Once you have addressed the OS-specific details, go your
build directory
(either the xc directory or the shadow tree created before) and
run "make World" with the BOOTSTRAPCFLAGS
set as described in the OS-specific README (if necessary, but most
systems supported by XFree86 don't need BOOTSTRAPCFLAGS). It is
advisable to redirect stdout and stderr to World.Log so that you
can track down problems that might occur during the build.
With Bourne-like shells (Bash, the Korn shell, zsh, etc.) use
a command like:
make World > World.log 2>&1
Witch C-shell variants (csh, tcsh, etc), use:
make World >& World.log
You can follow the progress of the build by running:
tail -f World.log
in a terminal.
When the build is finished, you should check the World.Log file to
see if there were any problems. If there weren't any then you can
install the binaries. By default the "make World" process will ignore
errors and build as much as possible. If there were problems and they
are not corrected at this stage, the installation process will fail.
To restart the build process after correcting the problems, just
run 'make'. If Imakefiles or part of the build configuration was
changed as part of correcting the problem, either re-run "make World",
or run "make Everything".
If you would prefer "make World" to exit at the first error, run it in the following way instead of the way described above:
for Bourne-like shells:
make WORLDOPTS= World > World.log 2>&1
for C-shell variants:
make WORLDOPTS= World >& World.log
To do the install, run "make install" and "make install.man".
Make sure you have enough space in /usr/X11R6 for the install
to succeed. If you want to install on a filesystem other than
/usr, make a symbolic link to /usr/X11R6 before
installing.