8. Rebuilding the XFree86 Distribution

You should configure the distribution by editing xc/config/cf/host.def before compiling. To compile the sources, invoke ``make World'' in the xc directory.

8.1. Perl support

Starting with XFree86 4.0.2, perl is needed to build the fonts in XFree86. Since perl is not included with standard NetBSD installation, fonts that need perl are not built by default.

If you have installed perl (from the NetBSD packages, for instance), add the line

#define HasPerl YES

8.2. Aperture driver

To build the XFree86 server with the Aperture driver enabled, you should unpack apNetBSD.shar and install it first.

Then edit xc/config/cf/host.def and add the line

#define HasNetBSDApertureDriver    YES

8.3. Console drivers

XFree86 has a configuration option to select the console drivers to use in host.def:

• if you're using pccons put:

   #define XFree86ConsoleDefines -DPCCONS_SUPPORT
  

• if you're using pcvt put:

   #define XFree86ConsoleDefines -DPCVT_SUPPORT
  

Experimental native support for the wscons console driver can be built by adding:

 #define XFree86ConsoleDefines -DWSCONS_SUPPORT

For the i386, you should include both pcvt and wscons support in order to use the pcvt compatibility mode of wscons:

 #define XFree86ConsoleDefines -DPCVT_SUPPORT -DWSCONS_SUPPORT

8.4. Building on other architectures

Note that the NetBSD project has now its own source tree, based on the XFree86 source tree, with some local modifications. You may want to start with this tree to rebuild from sources. The NetBSD xsrc source tree is available at: ftp://ftp.netbsd.org/pub/NetBSD/NetBSD-current/xsrc/